If it’s in corners only tune Pressure Advance, but as this is on the first layer it’s probably only the first layer, which is generally different from subsequent layers. Check the same thing on a higher layer to make sure that there really is a problem.
You can set the minimum extrusion width to a small value (20-25%) for better fill. You could also use classic mode with gap fill. You can use ironing for both to improve the results.
Does your slicer have Arachne slicing mode? It will use variable extrusion width which will help to prevent most of those gaps.
Your first step will be learning to dry it and keep it dry. I can recommend a scale that can resolve to at least 0.1g so you can measure the weight loss while drying. This will help in seeing when it’s sufficiently dry (put it in dryer and weigh it every hour) and if it took moisture again.
We better should’ve stayed at 640kB.
Room-scale DnD dungeons anyone?
It looks like there are multiple layers printed without feeding filament, which causes these frays to build up. Could it be that the filament clogs after this layer? Or do you see that filament still properly feeds later? This could happen for example due to heat creep and the filament getting too warm/soft in the extruder to properly feed or you trying to feed too fast.
The layoffs are finally paying off…
deleted by creator
However I can see when any IPv6 begins with 2a02:12xx:: then it’s Swisscom (biggest swiss ISP). But I can’t remember any of their hundreds of IPv4 prefixes.
You might be able to make it much stiffer by adding more of the arms parallel. The force should be consistent when you tighten multiple of them with one screw.
You have to choose the one without AMS color changer: https://us.store.bambulab.com/products/a1-mini?variant=41513493627016 It should be 199$
Bambu A1 Mini is on sale. Add a 0.2mm Nozzle and you have a perfect machine for miniatures
ExtensibleMarkupLanguageHypertextTransferProtocolRequest
You should ask the creator. Maybe he’s unaware that people can’t post makes anymore or it’s a setting they can change.
Make the movements visible in preview. Most probably it makes the total movement shorter when switching between parts.
For services I host I really like this EULA:
If the Provider of the Service (the “Provider”) needs a place to crash and you have a sofa available, you should maybe give the Provider a break and let him sleep on your couch.
If you are caught in a dire situation wherein you only have enough time to save one person out of a group, and the Provider is a member of that group, you must save the Provider.
THE ACCESS IS PROVIDED “AS IS”, WITHOUT WARRANTY OF ANY KIND, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO BLAH BLAH BLAH ISN’T IT FUNNY HOW UPPER-CASE MAKES IT SOUND LIKE THE LICENSE IS ANGRY AND SHOUTING AT YOU.
Edit: original found here: https://github.com/pirate/security-growler
Lower speed between the holes because of low acceleration. Because of this more heat is brought into the layer which makes it more shiny. Your nozzle doesn’t reach the same speed on a 20mm line as it does on a 200mm line.
Is it only me or does that CoreXZ kinematic not make any sense? They gain the ability to move in Z in high speed but add ringing etc. in Z direction.
You could use gyroid infill. It is more tolerant to flow as there are no crossings.