LazaroFilm

I read they’re doing a recall on the left bend one. The right bends are okay tho.

🎤🤚

Whoever sent cookies via mail didn’t think this through. That’s why cookies are usually wrapped in a plastic form to hold them in place and separated from each other or in a tight stack.

I really want a X1-C. A colleague has one and loves it. But I can’t deal with closed source and mandatory network.

What’s with the Queens Of The Stone Age album picture?

Time for republicans to split into two parties.

Why what are you drinking? — Oh it’s a Cabernet Sauvignon, 2003, with chestnut hints it’s delicious. — Me: it’s just moldy grape Juice. — no but you have to pay attention to the small nuances in the… oh.

First change. Install Klipper and run it of a Raspberry Pi.

Everyone recommend HomeAssistant and it’s great. An alternative that’s easier to implement if you’re using Apple HomeKit (on HomePod or Apple TV) is HomeBridge. It’s super easy to setup and becomes a bridge to make anything compatible HomeKit.

Too much coding for me. I read 10 milli as millisecond. And i was like what?

In cura switch to the preview mode to see the paths your printers will lay plastic at. It will tell you a better idea of what your final product will look like.

It’s at the top of a mountain.

I wish there was a 2D printing community like for 3D printing where you could build your own printer and run it off a Raspberry pi.

I like my canon with the megatank. No more cartridges. You can buy cheap 3rd party inks and refill when needed. It’s not open source but the drivers aren’t invasive. It has wifi but I didn’t set it up and just use usb.

That was the best pun. It’s all downhill from here

Every time I see those letters I think about the fact that I spent years not realizing that the movie Welcome to GATACA is a gene sequence.

NSFW!

I ditched the cartridge crap for an eco tank and it’s great. You can even buy off brand Ink bottle for super cheap.

sudo

What’s Pokémon home?